Vase Model Step 10

Reach underneath the top layer, and pull this side of the vase out.

 Pull the opposite side of the model out and into position.

Pull the remaining sides out, until the bottom is flat.

 The other two sides should come into shape much easier. You will probably warp the model during this process, which is fine. Just watch the locks to make sure they don't give.

Form the vase shape by reinforcing the folds, and stick your fingers inside to flatten the bottom so that the vase will stand up.

 As long as the locks stay in place, you should be able to stick a finger into the vase and finish working it into shape. There is some accounting for taste here, some people like the top flat, I prefer it to be a bit rounded, which helps the locks to stay secure.

Patterns and prints bring out the eye catching nature of this lovely paper vase.